Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are moving Cisco Wireless Controller and Server Switch from Core to Distribution switch. What all things needs to be check and do to ensure success movement (Apart from configuring the New Uplink ports and allowing vlan on Trunk port in path)
I understand Cisco Prime and DNAC are different product. DNAC have modern features like SDx, assurance etc. They have some similarities, special if I compare prime features with DNAC. But some feature of prime are not present in DNAC like Compliance,...
We want to connect two PaloAlto Firewalls (Active-standby pair) to our Catalyst Core Switch. Each firewall's two port will be connecting to Catalyst Core switch. Can we Bundle all these 4 port (2 from each Firewall) in single port channel. Note: At a...
Hello,We have enable TACACS+ AAA in our Production. Cisco ISE (TACACS+ server) is receiving accounting messages (configuration change notification message) when there is Configuration change on Switches. Now is it possible to enable ISE to sent ema...
Hello,In our production LAN Switch environment we have Cisco ISE acting as TACACS server, We have Cisco Prime managing all switches. Our Third party vendor have full access on our Production switches. We want to trace Configuration changes done by t...
Core switch is standalone 4500 series switches and also 9300,9500 stackedtogether. We don't have vss.As per the document default load balancing algorithm is destination basedmac address. So in my case it will be mac address of virtual IP address offi...
Hello Georg, Thanks for sharing script. While searching on this I came across one centralized solution based on TACACS accounting feature (Which is already configured on our switches).I also found our ISE server (TACACS+) is already receiving configu...
Hi Georg,Thanks for reply.I would like to try this, But before I configure it in production pleasehelp me to understand on below queries.1. How frequent EEM script will run and send email notification? every timewhen user enter new configuration line...
