Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone!We have a parking lot switch wich is WS-C3850-48P and uplink port goes through GigaBeam LR-Ubiquity link back to the distrbution switch, I checked everything on the ubiquity link including alignment and power, including port duplex but...
I have 9800 WLC with 500 AP which pointed to the main primary controller and would like to configure a secondary controller but I can't figure out how to have this to accomplish at once without going to every AP and edit one by one.Thanks
Hello AllI am new to Nexus and I have issue here hope someone can help:I have two switches in the network one of them is Cisco IOS C9500 which is a distrbution switch and the other side is cisco Nexus9000 C93240YC. I am trying to configure Port chann...
Hello Everyone!I wanna thanks everyone for any comment!We have a WLC 9800-40 with version 17.9.3 and there is around 143 AP's connected only one AP has an issue keeps dropping and connecting back to CAPWAP. and I am not a wireless guy couldn't figure...
Hey Everyone!I accidently factory reset one of the switches and used command "factory-reset all" instead of just a config. Now I lost the software image in the flash/: and lost all the pkg files inside the flash.how I can recover the software image f...
when it goes down it seems like from the remote side not the Distrbution side. but other than that bridge link we don't have any loop connection between two building
on the Distrbution side I don't see the link goes up/down and here is the log from this side it Nov 14 16:04:10.002 PST: %SPANTREE-SW1-2-UNBLOCK_CONSIST_PORT: Unblocking TenGigabitEthernet1/2/16 on VLAN0124. Port consistency restored.
Nov 14 16:04:10...
here is the log when it goes up and down Nov 20 11:18:49.156 PST: %PARSER-5-CFGLOG_LOGGEDCMD: User:d68885-a logged command:interface GigabitEthernet1/0/1
Nov 20 11:18:57.247 PST: %LINK-3-UPDOWN: Interface GigabitEthernet1/0/1, changed state to down...
Hi Balaji! yes the link is stable and is not that far awayI checked the negotiation and both sides are on AutoI ping the PC to PC and nothing dropsbetween adaptor and switch is 5ft
