Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyoneI have an AP 2602e the boot up is:Find image for Ethernet (3 times)Find image for DotRadio0 or DotRadio1(for this Interface the AP will find the image (WLC) )The AP 2602e is managed by WLC 5508 and it´s configured with mesh.I want chang...
Hi Guys
I´m studying for the CCNP Security 300-206 and I have a hardening topics, I want to know if someone has a good document for this topics.
Thanks
Hello everyoneI have configure in ASA VPNs with L2TP for Windows. I configure split tunnelling and I can't reach the network 192.168.1.0/24. But the other network I can reach. Note Important: I have configure other VPN with AnyConnect and I can reach...
Hi I resolved the issue, the cause of the issue was that I have configured a site to site VPN and I have a policy with source 192.168.1.0/24 and destination any. Then the traffic the VPN L2TP applied in this policy. I changed the destination in this ...
I have the same issue and I solve the issue with change these parameters.1.- You must change on configuration profile "before user logon". I have 5 seconds2.- You must change on configuration profile "port authentication Exception policy" and you mu...
