Change Boot up 2602e

[dllaulen20]

Hello everyone

I have an AP 2602e the boot up is:

1. Find image for Ethernet (3 times)
2. Find image for DotRadio0 or DotRadio1(for this Interface the AP will find the image (WLC) )

The AP 2602e is managed by WLC 5508 and it´s configured with mesh.

I want change the boot up, the AP takes too long to find the image.

Regards.

[keglass]

David,

I recommend you also post this to the Cisco Support Community for additional information and feedback.

https://supportforums.cisco.com/

If you think you are experiencing a bug, then please open a ticket with Cisco Technical Assistance Center (www.cisco.com/go/support), where they can help you investigate the issue and can offer expert debugging assistance.

I hope this helps.

Kelli Glass

Moderator for Cisco Customer Communities