Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have deployed two 1010 appliances, the upstream switches are two 6509 wihtout VSS.I cannot get the HA up.Output of show module is:Mod Ports Module-Type Model Status--- ----- -------------------------------- ...
Hi,Initially we deployed VSM on a VM and that was working fine. Now the customer has bought a 1010 appliance and wants us to configure VSMs on the 1010 appliance.I just want to confirm that the steps that I can up with after going through cisco docum...
Hi,we are using a single link to connect to the core switches, this link will be carrying all control, management and data traffic.VEM physical uplinks will also be configured as trunk.Can gre tunnel for VSM - VEM communication in L3 mode be made on ...
Hi,I have a 5548 that I need to connect to a firewall that supports 100 Mbps only.Can I configure interface speed on Nexus 5548 interface (GLC-T) to 100 Mbps inorder to connect it to the firewall??Regards,Sabih
Hi,I wanted to get some information about deployment of Nexus 1000v in L3 mode.All I have to do is:Configure VSM domain transport mode as L3.Configure vethernet port-profile for control vlan with capability L3Configure VMware kernel NIC and apply con...
I have implemented Uplink type 2 and for the time being just connected first two ports only, I have not connected any data links i.e. eth 3 to eth 6 are not connected.
Hi Matthew,I have gone through the migration guide. Thank You.But I was more worried about the 1010 intial configuration. After the initial configuration, do i need to deploy VSM as a VSB and then migrate the working VSM or I can simply create port p...
Hi,I have configured similar port-profiles.We have deployed VSM on a VM and using vswitch for management purposes therefore mgmt0 is connected to vswitch, and I have configured control0 interface to be used to route l3 traffic.And added control0 int ...
Hi Michael,I have done all that is in the domain configuration document.The problem that I am facing is that the IP address that I am configuring on the vmknic is not pingable.Can we ping the vmnic IP?? I cannot ping it from with in the same subnet a...
