Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
can I change the VLAN name on a switch and all the ports that are set to that VLAN not be affected? Some of the VLAN names are outdated and would like to update to more informational names, but don't want to cause connection issues.
I know a load balancer or any other equipment between 2 devices obviously introduces latency. But when a client initiates an SSL connection to a server through the LD it seems to take about 5 seconds to hand the request off to a server. And this is o...
I use LD 416's for internet web site load balancing. works great. I'm looking to load balance some intranet web sites and some DCOM or COM+ servers. Will LD balance COM+/DCOM? Clients are connected at 10/100 and servers are at 1000. Wont the LD be a ...
How can you tell what sig version you are running of CSPM? I know is says what actual software version you are running when you start it, but where can you see the Sig version?
I am running CSPM 2.3.3i S17a. Every sensor that I go to and click on Filter tab, then Advanced filter, then click Add, I get the message "You must select a sensing template in the Sensing tab before you can define any filters.". All my sensors are u...
your right, that was what it is. but the problem I have now is, i setup my 2 sensors for IPSec and did them both the same way. one works fine but the second gets "error - can not communicate with sensor". I did everything the same. and I have tried s...
