Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experencing an issue where when I attempt to session into a module (IDSM-2 in this case) it returns an error "telnet connections not permitted from this terminal" which doesn't make sense to me. I normally run the IDSM with the telent server dis...
Hi,I have three 6500's, 2-6509's 1-6506 all with 2500W ps's. In one W6509 and one P6506 I have that 10/100 I mentioned it's using 100W and 2.46 amps. The other A6509 is using twice that 200W and 4.79Amp.on the same 10/100 module. The only difference ...
Security Monitor/IDS Monitor do not support the 5.0 IPS. I upgraded to 5.0 on a ISDM-2 mod, first I had a hard time getting a licences (They hadn't updated there Smartnet IDS contracts Db so that they covered IPS support) , and then I couldn't import...
Good luck. I am currently waiting for someone at Cisco to tell me if a valid/active Smartnet(I have 24x7x4's) will get you a lic. I attempted to obtain a lic this am and was rejected and told I had to buy a product entitlement.
An update. The relese notes http://www.cisco.com/univercd/cc/td/doc/product/access/acs_soft/csacs4nt/acs32/rnwin321.htm state that ACS v3.2 is SP 4 ready.
