We are setting up a new router, we have found that the conventions vlan commands are not used any longer. We have a single mode GBIC, which we want to run 3 vlan over. In the specs it says ILS vlans cannot be used. Does anyone have an example of an N...

I have created a gateway based on a 2651 XM, using an E1 isdn 30 bundel, made the Coral qsig master and CCM qsig slave. Everything works except one thing Calling name identification presentation as per ISO 13868 does any one have an idea if CCM meets...

I am having a problem with a c2621XM with an AIM voice 30 module and an E1 PRI vwic. I see the aim using the sh pci aim command but if I use the sh diag 0 command the AIM module doesn't show. as a result I cannot get the 2600 to go into voice mode as...

I have running version 3.1 of unity. We have more than one organisation using our CCM. We would like to be able to use a single unity server to service more than one exchange 2000 server. We have setup a master AD domain and have trusted the two sub ...

I have a ccm 3.1 system, with an ATA186 attached did all the setup for a fax works ok. On a good day I tried to send a Fax of 12 pages, each time it stops at page 4 or 5. Does anyone have ay idea of waht can be causing this and how to fix it.