Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWe have CUCM v12.5 and UCCX v11.5 in our newly deployed HQ.All phones in HQ are registering to the CUCM_Pub. 3 phones need to place in another branch which is connected to HQ via WAN (VPN) but when we take phones to the branch site they are not ...
I have Cisco ISR 4321 router with VIC-4FXO card installed. It’s running CME version 11.5. I’ve configured TCL script for AA (Auto Attendant) which is working fine as it is supposed to be. (CUE is not installed)
When someone calls from outside (inbo...
Hi,
I have 7 (Catalyst 2960-X Seires Switch) as Access Switches and one Layer 3 (Catalyst 3850 XS 10G SFP+) as Distribution Switch. Each Access Switch is connected to the Distribution Switch with SFP port. I have 5 VLANs, and certain ports of each ...
when I bypass TCL script then port is released after few rings are not answered... but when it is passed through TCL Script the port is not released until I "shutdown" it and then "no shutdown"
P.S: when I'm bypassing the TCL script, it rings the ...
I applied following commands (taken from the mentioned link) in Voice-port but still same situation..
https://supportforums.cisco.com/t5/ip-telephony/fxo-incoming-call-disconnect-problem/td-p/2203774
!voice-port 0/1/1 supervisory disconnect anyt...
hi Georg,
I'm in Riyadh, Saudi Arabia. We are using STC analog lines. I just called in STC help line and the representative told me that these are "Loop Start" lines.
I've read in the mentioned post that there is a bug in Loop Start in STC analog l...
In fact, the NAT commands I entered are accepted but i couldn't see their effect.
Without confirmation from Cisco, I supposed that there might be some bug or problem, so I sacrificed InterVLAN routing for DATA VLAN 30, and put;
!interface TenGigabi...
