Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to allWhen I click Help button and some function button it show Host Not Found.I didnt find documentation for this.Thanks in advanceWith regardsDubravko
HiCan you give me a advice me why I cannot connect from Broker: 10.11.3.5:9002to Domain:dfmWhen I click connect it shows:Cannot attach to Domain DFMDomain DFM not register with broker
Hi to allI have ITS 2.1, communication between bouth analog and 7940 is working fine, but analog phone cannot call second analog. IT rings busy. I have tried with g.711. I have ried g723r63 it also rings.Thanks for help in advanceWith regardsDubravko
Hi I need Pro to answer me how can I build destination-pattern for those numbers. I cannot find the solution. I think that is impossible. Final solution is to write 10 destination pattern.5010020030004000053113213301340013Thanks in advanceWith regard...
Hi to allI have Unity 3.1 Build 3.1(5) and CCM 3.1(3a). On gateway is codec g711ulaw set. I can send voicemail, communicate over phone with Unity, but Call Transfer does not work. Any of options doesn’t work. Any suggestions?With regardsDubravko
Hi UllieIt is simplyst like it says. You now when you click ? button on IP phone that is connected to CCM it says for redial "To automatically redial the last number ...."I missed something in configuration.With regardsDubravko
HiThanks for solution. It works perfectly. I have rad abut it but I didnt have MS firmware.Solution for MAC addresses is like in VG248.Thanks againDubravko
Hi Taimoor I have reading about configuring MAC addresses, but all I can found is COnfiguring ATA for MGCP, SCCP, CallManager. Do you now any document for configuring ATA for H.323 and ITS 2.1?I have files:Cisco IOS Telephony Service Version 2.1.pdfC...
