Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Mu customer is claiming that access codes generated by BBSM administrator are visible on the administrator screen, so the administrator could access the internet, do something illegal on behalf of the user. My customer would like access codes to be g...
In a test lab, I have implemented a backbone using 4 6500 switches connected in a square configuration. The backbone is using MST, the four 6500 are in the same MST region. Then, i connected two 2950 switches to the backpone. The 2950 are not using ...
I fell in the problem described in http://www.cisco.com/en/US/partner/tech/tk827/tk369/technologies_tech_note09186a0080093f1f.shtmlA server sent a MTU greater than 1500 and the frame wasn't able to pass thru a GRE tunnel.I am asking if the same probl...
Somebody told me that a Router should not a act as DR/BDR for more than 1 LAN segment. In my specific installation I have a 4506 with SUP IV that acts as DR for 5 Segments. Are you aware of such limiation or do you have some link that refers to this...
I am not able to find any example showing that QLLC is supported also for FEPs.My configuration should be the following:FEP-LAN-ROUter-X.25cloud-router-LAN-FEPIn other word I need to let two FEPs to talk trough an X.25 cloud. Each of the two FEPs is ...
This is not what i was looking for. I would like to prevent BSSM administrator to see in clear text the access codes assigned to a user. As you can see on the attached BBSM attached pintout, administrator is able to see the access codes. Moreno sarto...
As i tried to explain, the network behaves in different way depending if we are using QinQ or not. Using the same topology, without QinQ, traffic on vlan X between the two 2950 is interrupted only for 1 sec, if we mapped lan X on lan Y, traffic is in...
In reality the configuration is more complex than that I described. The two FEP are not owned and controlled by the same customer; one of them is not under our control.On my site, I have a x.25 line that is now connected to the FEP; I would like to c...
