Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our 7914 work fine with 7960's. Hook up 7914 to a 7970 and it remains blank for speed dials. Looks good from CCM and speed dials can be added, they just don't display on the 7914.Sean.
I have searched the forum and cannot find a post on this. Where can I modify the number of entries returned? I am aware of the consequences of this change. We wrote our own asp that returned all. We have recently put the default directory.asp in ...
I have 4 TTS ports that I have never used. Clicked the check box for TTS in COS and enabled email notification. Call into Unity, says you have a new email, but no option to listen to it. Is there a link that gives the basic setup steps to make TTS...
We point to our publisher as the directories URL. It is the secondary CCM. If I pull the publisher from the network, no one notices since it is not the primary CCM, but the directories button is now sending users to a URL that is off-line. Was thi...
I have 6 clusters with ICTs between all. I can access them with my publisher/tftp server as primary call manager. I stood up a subscriber and made it primary. Switch over registration and switch-back work great on the inside the cluster, but getti...
Thank you. It was right under my nose. I can change the value on my CCM 3.3, but my operational CCM 3.2 server will not allow any value greater than 64. Looks like I am stuck until I upgrade to 3.3 or later. Thanks again.Sean.
Walid, The answer is yes. We do this. We have 6 clusters and we modified the asps so when you do a directory on the phone you see the entries for all 6 clusters and can do searches on any of them.
Found the answer in the following post:lindborg - CISCO SYSTEMS Jul 11, 2003, 10:20pm PSTI was config'ing the COS for default subscribers. I just needed to search for Default Administrators and do the same thing. TTS is working.
