Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,In this crisis time I spent most of my time in helping customers to work remote. The good thing is also that there remain some time to follow trainings and Webinars.As Cisco partner for a long time, I'm questioning if it is not interesting to swit...
Hi, I have a wireless network with only one AP 1832i. He is master controller and runs the Mobility Express firmware withthe release 8.5.151.0.Now I tried to join a new bought AP 1832i (= Lightweight Access Point) in the network but after hours the j...
Hello,
I'm struggling to have the correct timeon my SG300 device. Manually time setting is for me not a good solution because each time the device has a power down the device lost the time. So I want to use a public SNTP server.
I tried already a S...
Hi,
The installation/configuration of first AP (with the mobility express image) was straithforward.
Installing the second AP (I have to do 6 AP's) does not work. After connecting the new AP on the switch (SG300-10MPP) I can see the new AP in the...
@bcrossen I fully agree with you.I work mainly with the Cisco small business switches and Mobility Express controllers but sometimes to have the installation up and running you need to work with 'CLI-commands'. Which is time consuming if you don't do...
Thanks, GldenIt seems you have a lot of experience with the Meraki portfolio. Because your answer is clear and convincing. This is the best "exchange of idees" we can have someone who talks from practice.Thanks again, for sharing your insigth !
@joey.debra Thanks for your feedback, I see the answer is near by house.Now, it is clear where to position Meraki Go.Just one more question. Is it possible to merge the devices of Merako Go en Meraki ? Starting with Meraki Go end end up with MX, MR's...
