Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a SDSL G.DMT service with Zen.We have purchased an 878 and put a basic config on it.It refuses to show even a CD led when connected up to the copper wire.Has anyone got a sample config for the controller which shows all the lines needed to g...
This is a sort of generalised question. Someone has asked, and am actually scratching my head thinking that he has the wrong end of the stick entirely and I want to put him straight.The sceanrio is:we are going over to another ISP for our Internet/si...
This is just a general question to which I would a simple yes or no will suffice:Company has a Web server on a single DMZ. External customers process orders via Internet on this server.The Server, however, must pass all information back to Oracle ser...
I am investigating the use of AIM cards in 2600 series routers. Has anyone successful experience of compressing data on a 2600 then pushing it out via an ethernet port to a firewall and then out to the internet over VPN to another office with the sam...
Am I making life difficult for myself?I would like adhoc PCAW access thru a NAT router to a host on the LAN.At the moment NAT is using the WAN ip address (dynamic).Is it possible to create a static mapping to allow tcp port 5162 and udp port 5163 to ...
There is no NAT involved at our end...the ISP's routers at our sites have default gateway config lines pointing to our Firebox connected to another Internet gateway router on separate serial line..again all NATing if any done by ISP.As I say this is ...
Cool!but I have to put the IP addresses of the serial routers ethernet ports in place of serial 0 and serial 1 ?Not bothered about load balancing as such..just want both routes out active and useable for a month, until we switch ISP 1 off.by the way ...
This is getting me somewhere!So, bearing in mind that I will have the line:ip nat inside source list 1 interface Dialer 1 overloadI think I just need to add in your suggestion as follows:ip nat inside source static tcp 192.168.0.5 5631 interface Dial...
Looking at the config, you have IP negotiated for the links. Won't you need static addresses so that routing tables know when something has failed to bring up sec link?Just a thoughtSteve
Soemthing like what you are trying to achieve has also preyed on my mind - up to now i havent needed to implement anything.The link http://www.cisco.com/en/US/products/hw/routers/ps380/products_configuration_guide_chapter09186a0080118d24.html#1077339...
