Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If the EIGRP metric is given by the following formula:metric = [K1 * bandwidth + (K2 * bandwidth) / (256 - load) + K3 * delay] * [K5 / (reliability + K4)]why the defaul formula is given by:metric = bandwidth + delayif k5 default value is zero (0) and...
I have two Catalyst 6513 switches connected by a two gigabit ethernet port channel trunk port. VLAN 5 exits on both switches. I have 4 routers connected to switch A on VLAN 5 and 3 routers connected to switch B on VLAN 5. Because, this routers are...
Hi,We are an ISP network and we are about to have a new conenction with a new upstream provider, what do you think is the highlight information we need to know about the provider before deciding taking it as our new upstream provider? Besides cost, i...
I would like to know the similarities and differences between the NAM module on a 6513 Catalyst switch and the Netflow tool, can the NAM module do everything netflow does? if you have a link regarding this info, please let me know cause we are about ...
Maybe they´ve blocked your ip address block, that was happenning with us. I recommend you to discard any routing problem, first check on a looking glass the ip address of the web page you cannot reach and them check if you´re learning the route to t...
Hi, The web pages do work from other ISPs.I am trying to reach the web pages from our backbone and i can´t reach the pages so i think it isn´t a DNS problem.The web pages has IP addresses from one block that i am learning from our border routers and ...
Thanks for the link!, it gave me the information i needed to understand what was and wasn´t being cef switched in my routers. I could decrease the cpu of one of the routers in almost 25%, cause i have a GEIP+ module (slot 10 of my 7500 router) where...
Hi,the sh align showed neither aligment data nor spurious memory . being recorded. Here i send you the show cef not-cef-switched output.cha-serv-00#show cef not-cef-switchedCEF Packets passed on to next switching layerSlot No_adj No_encap Unsupp'...
Hello Steve,I want to tell you about how the situation is going. After looking at the router and switches on the backbone we concluded that the problem probably was that distributed cef was disable on the router, this because the vips on the router (...
