I have Css-11503 with 7.10 version software.Management ip address is 172.16.1.1/24Interface Fa1/1 bridged to Circuit 1Circuit 1 -- IPaddress is 10.0.0.1/24Default gateway is 10.0.0.100Problem no.1 : When I do a traceroute to 172.16.1.1 trace follows ...
My router IOS is 12.0(21)S7How do I change the SNMP version to version 2 Presently it showsRTR#show snmpgroupname: test security model:v2creadview :v1default writeview: <no writeview specified>notifyview:...
I am running MRTG for monitoring graph utilizationof my network devices.When my router gig port traffic goes more than 110Mb.Mrtg shows cutoff or does not show any traffic.Has anybody came acrross this problem?Is there a remidy for the same?Thanks in...
Hi,My CISCO 6509 Chasis shows very high CPU utilization.When I see the processes running, L3 aging process is causing the problem.sh proc cpuCPU utilization for five seconds: 98.40% one minute: 99.00% five mi...
Hi,If your VOIP application source and destination is at a single location having VLANS seperating data and Voice traffic will be a good idea.If the VOIP source and destinations are spanned across wan segments you need prioritize the traffic over WAN...
Most of the modules for 6000 and 6500 are common.6000 does support 10/100 modules.Pls refer for more details ->http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/6000hw/mod_inst/01overvw.htm#1015129
Hi,You can configure the the PVLAN any time.However,if you have to configure PVLAN in the production environment using the existing VLAN ID as primary, there will be a downtime while migration.I would suggest to go with PVLAN design from the beginint...
Engine 2 line card does support per-packet load balancing.However Globally you need to enable per-packet load balancing for the line card.(per-destination is by default)(config)#hw-module slot number ip load-sharing per-packetYou will not be able use...