Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have Both NCS540 router and getting GTP loss on site, now i want to configure ECMP for load balancing, one media is MW and Secondary media is UBR so pls suggest how can i configure ECMP and how can i sure ECMP are working fine in router ?
Hello, I am not able to Default or admin up 10G Port Getting Error while going in Config mode " This SDR's running configuration is inconsistent with persistent configuration.No configuration commits for this SDR will be allowed until a 'clear config...
Hello,My Device Cisco 920i Router has hang and after reboot the router has came up, When im take console during hang ..im getting FPGA fail logs... PLs suggest what is FPGA and why my router has going hang mode ??
Hello,
We are getting below logs from my router, Kindly confirm why its generated.
model : ASR-920-10SZ-PD
005879: Nov 25 08:24:13.338 IST: %IPV6_ND-4-LOOPBACK: Looped back NS(DAD) packet detected for FE80::72DB:98FF:FE4E:94BF on BDI355
Yes i was do that, but after few minutes again all the only port are goes down. and Cisco are suggested to replace the router.but my confusion is, what is the exact reason to came this alarm in 920I router only ??
Hey,Now the port has up, after shut no-shut commmand.but there is common issue, every time if we have connect new equipment on the port, without shut no-shut its not came up.and we did not found any logs in router. RegardsSam
