Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm installing a HWIC 2SHDSL in a 2821 HWIC Slot 0 running IOS : c2800nm-entservices-mz.124-12.bin.I'm getting this message : %GT96K_FEWAN-1-UNKNOWN_WIC: NM slot 0, wic card has an unknown id 50E.Can anyone please tell me whats wrong - it's a brand n...
I need to check IP-helper statements with SNMP, and by using (locIPHelper) 1.3.6.1.4.1.9.2.4.1.1.3 it only lists the first IP-helper under each interface (IP address).Ex.:1.3.6.1.4.1.9.2.4.1.1.3.xx.xx.xx.xx => yy.yy.yy.yyxx.xx.xx.xx interface IP add...
I'm doing a clean-up on several switches, but i'm, unable to remove the following line :snmp-server view vlan1filter ccitt includedCan anyone help me ?
I am trying to map the physical interfaces on a router with their IP adresses.I am looking for the MIB object-tables to use for this - can anyone help me ? ffu@dk.ibm.com
Thank'sNow I know that SNMP isn't the way.I have to check app. 1000 devices and due to tacacs timer (30 sec's) CLI is out of the question. The CISCO-CONFIG-COPY-MIB and TFTPcould be used, but most of the devices are managed and maintained by a ISP, w...
I think this table maps IP addresses to MAC-adresses.What I need is :My GigabitEThernet 0/0 has IP address ? Serial0/0/0 has IP address ? and so on for alle interfaces on my router
