Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to setup my PIX 501 to work with my cable modem but I'm not able to get access webpages. My PC pulls a DHCP address from the PIX and my PIX appears to be pulling a IP, Subnet Mask, and Gateway address from the cable company. Below is my ...
I have a branch office that experiencing an outage around the same time every day. I think I have narrowed it down to a new 2950 switch, but I'm not sure. I'd like to use SNMP to help me isolate the issue but I'm not sure which Traps should be enab...
I want to protect my laptop users with a local firewall but I understand the build in firewall with XP is not compatible with LEAP. Which software firewall is.Thanks..
Just recently we segmented our WAN, and Remote LANs. We have 4 branch offices and about 3 home users that before had no trouble access network resource at our main office. Previously our WAN was one big network, no routing only bridging, they were ...
I change the config a bit and added the DNS entries of my ISP and I'm able to reslove webpages now. However a new problem came up was with the speed. With the PIX in place my cable modem speed dropped to that of a 56K dail up. Any ideas on that??T...
The problem is that I don't have a VLAN setup. I have recently inheraited this network and I have 2 Netgear switchs, 2 Linksys switchs, 1 Cisco Hub (400 series) and 1 Cisco 2900 switch. I'm trying to add a new 2900 switch and I'm not sure how to se...
