I have a branch office that experiencing an outage around the same time every day. I think I have narrowed it down to a new 2950 switch, but I'm not sure. I'd like to use SNMP to help me isolate the issue but I'm not sure which Traps should be enabled, plus I'm not as not as knowledgeable as I'd like to be when it comes to SNMP. Today when the outage happened I was notified immediately so I did a show log on the switch and the following attachment was what I found:
To me it looks like the switch rebooted, but again I'm not sure if that's the case or not. But if it did and it's doing that everyday around the same time I'd like to know why. I figured SNMP can tell me, any suggestions??
Thanks...
