Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all, I want to advertise 2/25 to our upstream providers Both have different ASN. I How can i set BGP attributes so that I can advertise 0/25 for one ISP and 128/25 for other ISP. Please note that our ISP advertise /24 rather than/25 to t...
dear Experts,
I am studying Graceful shutdown of Eigrp. and found that this feature is enabled by default in Cisco.
whenever we remove any network from topology it will automatically remove route rather than wait for hold-down time and send terminate...
hi all i am working on rip
i want to break rip updates by denying 224.0.0.9
which is not working
my configurion
access-list 1 deny 224.0.0.9 0.0.0.0a
access-list 1 permit any
int fa0/0
ip access-group 1 in
ip access-group 1 out
but still, hav...
Hi every one.
i am working on l3 ether-channels my topology is as under...
as mentioned in above pictures...
when is run command show etherchannel summary
all the 3 switches show me RU ( R l3 and u In use) they are now showing me down then ...
dear all,
how can we define the segments in stp network...
i am learning that 1 designated port in each segment?
what is segment in root bridge and non-root bridge
Dear bobby,yeah i used standard access-list, but after guidance of first reply i tried for extended access list still it is not working.i know about passive interface ,it stop sending routing updates i tried it is working perfactly...But i want to bl...
Thankyou for your reply,i tried it but still it is not working .rip is still learning route from neighbori also did clear ip route *show access-list 10110 deny ip any host 224.0.0.9 (312 matches)20 permit ip any any ( 12 matches)inter fa0/0ip access-...
Thankyou.ok one more question, In L2 etherchannel we use no switchport its mean its l3 port , there is no concept of vlan in l3 port,then why these ports are assigend to vlan 1006 to onward.command:show vlan internal usage
