Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure WCCP between Cisco Cat4507 & bluecoat , it is working fine for HTTP but not for HTTPS . The following is my configuration BlueCoat :wccp enablewccp version 2service-group web-cache forwarding-type L2 assignment-type mask mask...
I would like to use PEAP with ACS 4.0 , I follow a doc from Cisco but no luck.* can any one help me how to deploy PEAP ?* What is the different between PEAP & WEB ?Thanks
Hi , I'm trying to configure 4507R ( 12.2(31)SG )to run WCCP as shown in the attachments.1- I enable WCCP globally 2- In users VLAN redierct HTTP in .3- In bluecoat configuration iswccp enablewccp version 2service-group web-cacheforwarding-type l2pas...
Iftekhar,Thanks for your replay .Do I need to use the following command* ip wccp 70 group-listen under the interface link to the BlueCoat , if yes How can i enable several service group in bluecoat ?Thanks
Thank Andera ,1- There is no firewall2- I can Managet the Bluecocat from Users VLAN .3- I tried with no password but no luck.4- Cat4507R does not support GRE that is why I'm using forwarding-type l2 .5- CoreSW1#sh ip wccp web-cache detail WCCP Cache...
Hi , If the network is connecting the Internet through the PIX do the following : 1- In remote router configure defualt gateway the main office ip route 0.0.0.0 0.0.0.0 192.168.1.2502-In the main route configure default gateway to PIX ip route 0.0.0...
