Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Now that YANG Suite is installed and running, lets understand a bit more about what is required on the device side. In this case the device is Catalyst 9300 but could be any of the switching, routing, or wireless devices running IOS XE that support N...
YANG Suite is here
Well after a long anticipated release the YANG Suite tooling is finally here. Lets take a quick look at some resources for the tool as well as the getting started workflow once it has been installed and is running.
Resources
De...
Hi Damien, I work mainly on C9K switching, so C8K is my speculation.... the Docker subsystem was not enabled on the routing platforms like it was on the switches. You can use a KVM but not a Docker is my understanding.
Yes use the API NETCONF/RESTCONF or gNMI API to edit the NACM module like discussed above.
There are also 2 CLI you can use it to populate a read-only example and specify the privilege level (in your example prove 10 in my example I use priv1)
Co...
Unfortunatley a lot of people care about it now all of a sudden...
"Long story short: No! However I have the feeling nobody cares about it and I'm the only paranoic person around"
You need to install the restconf plugin, pip install yangsuite-restconf.
Share the log from the 500 error, what plugin are you using, what workflow is causing the error? Please make sure to use latest versions too!
