Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have DNAC 2.2.3.4 supporting 9800L WLC (17.3.x).I need to change the RF profile on 100 APs. Is there a way that I can push out a job to change the RF Profile tag on those APs? This is not a fabric deployment. The 9800 was setup and then discovered ...
I had a 9200L-48 fail at a remote site. Cisco shipped an exact replacement to the site. The RMA workflow failed when trying to replace the switch.1. I marked the failed switch to be replaced.2. I entered the new serial number as the replacement switc...
I have a brand new 9800 that has no health score. DNAC is not giving any client health information. When it was discovered, status, icmp, snmp,cli, netconf all had green checks.Brand new Brownfield 9800L, Version 17.3.3 ESW10DNAC, Version 2.2.2.5 I h...
I have two cloud 9800s in AWS running 17.3.3. All of the APs are in FlexConnect mode. Can you please change the code in the controller so the TAGs are written to the AP when the AP is initially configured? I have to configure every AP twice when the...
I setup DNAC Version 2.2.2.4 to send alerts on events. I have a router that is hot and DNAC sent me about 1,000+ emails today about the hot router.- Is there a way to suppress or limit the alerts so I don't get so many? Maybe one a day until it gets ...
I tried the AP filter and it didn't work.I used this last week on my C9800L with the APs in local mode (17.3.4c). This worked, the APs were already registered and it applied the config. When I tried this filter on my Cloud 9800 running the same code,...
I have not performed any configuration from DNA Center in the past.I configured them, then discovered them via DNA Center. Now I have a need to change the tag on a bunch of them.
I could do this to start with. However, if the tags ever change, I would have to go do this on both controllers every time. I have a team of folks working on this. I have trained them to write the tags to the AP. Unfortunately, this seems like a bug.
I am not able to upgrade past 17.3.x due to compatibility issues. The 3700 series APs are not supported in 17.6.x.My other issue is that everytime I use a .0 or .1 release, I get run into tons of bugs.17.3 does not have "Enable AP Tag Persistency". W...
