Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am still trying to have this PAT translation and NAT issue resolved. Here is what I have done: |------------> DMZ1 (security90) | (172.16.28.0 255.255.255.0) | | | INSIDE (s...
I am replacing the flash on a PIX-520. I installed the new flash card and got lights, but nothing on the console. I switched back to the old and all is fine. The device has 32M of memory. Do flash cards come with a PIX OS installed? Can I request a s...
The memory has been installed. I completed the install over a serial on several IDS-4230 devices. I figure I need to enter the BIOS and change the boot sequence.
bash-2.05a$ ls -ltotal 14096-rw-r--r-- 1 netrangr cids 12243162 Dec 1 19:58 IDS-K9-sp-4.1-3-S61.rpm.pkg-rw-r--r-- 1 netrangr cids 2163363 Dec 1 19:58 IDS-sig-4.1-3-S62.rpm.pkgbash-2.05a$ ls -l /usr/cids/idsRoot/var/updates total 24dr...
the files were copied to the /home directory of the local user. The device shows:IDS-4235# sh verApplication Partition:Cisco Systems Intrusion Detection Sensor, Version 4.1(2)S58OS Version 2.4.18-5smpbigphysPlatform: IDS-4235Using 909631488 out of 92...
I had a similar issue where the PIX interfaces would clear (go to normal status). Basically, check you config and possibly debug the failover messages. Basically on the logs, I had: Deny inbound protocol 105 messages which meant the failover traffic ...
