Hi, I would like to understand the host keyword mentioned ACLs logic and the procedure to use them in blocking subnets from redistribution. (Below is the example ACL) 10 permit ip host 100.0.0.0 host 255.0.0.0 Kindly give an example Regards,Antro
Hi, I want to redistribute OSPF e2 routes into BGP. But OSPF E2 external routes are not getting redistributed into BGP without " redistribute ospf 1 metric 3 match internal external 2". Below is the key config and would like to know the alternate way...
Hi,
I am configuring MPLS L3 VPN. I wanted to know whether the local and the remote PE devices should have same VRF configured to share routes between them. I have given here my local PE BGP local config. (If possible pls share example configs)
...
Hi,
I am not able to reach router interface from the l3 switch connected l2 switch. The topology is R2 <--> L3 Switch <--> L2 switch.
The config:
R2:
interface FastEthernet0/0ip address 10.2.2.1 255.255.255.0duplex autospeed auto
interface V...
Hi All,
MLS-1-1#sho ip route 10.213.192.96Routing entry for 10.213.192.96/32Known via "ospf 100", distance 110, metric 115, type intra areaLast update from 10.213.192.109 on FastEthernet3/22, 00:01:29 agoRouting Descriptor Blocks:* 10.213.192.109...
Thanks, for the reply. I am still confused between route leaking and inter vrf routing. Can you explain the similarities and differences with use cases? Regards,
Thanks. I got it now.
I still have queries.
Is there any relationship between NLRI and RT and BGP signaling ? How the NLRI will be used to identify destination ? what Is it command that enables MB-BGP?
Ok. I am trying this from GNS3 using IOU images. They are accepting the ip routing command but the same not appearing in the sh run result. any suggestions?