Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Im kind of new to this cloud platform of Cisco. Does meraki mx have PBR? I was planning to route 1 host from our network to a specific public IP on my secondary WAN but not using the interface IP.Thanks in advance!
Hi,I was wondering, is it possible to assign 1 Public IP to a specific vlan/subnet other than the interface IP?eg. WAN Interface IP - 1.1.1.1I would like my VLAN 99 to be statically assigned to 1.1.1.2 not the interface IPAll I can see is the 1:1 NAT...
Good day,
I would like your help regarding my simple topology. Here it is below:
I was trying out my failover by shutting down interfaces and seeing if an automatic failover occurs. All is working but one. When I shut down the Gi0/24 of the L3...
Hi Experts,
I would like your help regarding my issue on my Active/Standby configuration on my ASA.
Here is my topology and configuration below to better understand:
ACTIVE ASA CONFIG
failover lan unit primaryfailover lan interface FAILOVE...
Hi,
I have a scenario where we have 2 Cisco 5516 Firewalls that are configured as Active/Standby mode. Here is a simple topology below:
Now my issue is, I would like to have my Inside link to be redundant. Meaning if for example, If I unplug the...
Not possible in my case I think. Our MX only has 2 WAN interface and we have 2 ISP each with /26 public IP blocks.Sucks to migrate to a cloud platform that lacks functionality. I hope 'Make a Wish' will help fix this issue in the future.Thanks again ...
Thanks for the response jdsilva.Is there any work around on this issue? Because we availed a public IP block of /26 hoping that we can configure a per subnet=1 public IP.
Hi Julio,
Thanks for the reply!
by my understanding on your configuration, I would need to dedicate 2 ports on my Primary ASA to configure redundancy, right?
How about my Secondary ASA? My goal is that, when my connection from L3 switch to Prim...
