Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,RT, it's very strange. Did any one meet that situation please?Internet----Gateway(Cisco router)----CiscoSwitch----My end pointWhen my end point is a PC connected, and ping to the gateway, it's fine. But when it switched back to the C851, aft...
Hi, Dear Bros and SistersBranch_1_Router=====HubRouter=====Branch_2_Routerif there is a AIM-ATM card on the HubRouter,with 2 2-port E1 cards, can the HubRouter support the above connection Please? ( Two 2-E1 IMA connections on the HubRouter with ONE ...
1.I have a ASA5510, can it act as both SSL VPN server and IPSec VPN Server? BTW, the SSL is with the Client Software.2. I knew that with IPSec VPN, we can config a aes-256 Encyption, but with SSL, can it be config that high on the ASA5500?
Dear guys, can you give me an idea pls?Big thanks in advance.(Internet)-------(ASA5510)------(192.168.2.2)------LAN-------PC``````````````````````````````````````````````````````````````|``````````````````````````````````````````````````````````````|...
Hi, Dear all:After I build a EZVPN server on a C2811, I found that after each connection, the VPN alway broken after the time set in "the Peer Response Timeout Value" on the Client soft.How could I stop this situation happened please? Thanks a lot in...
Hi, dear all:I think the promblem is total resolved this time althought some related messages were post before.The Key factor is the "Reverse-route", but I input the "reverse-route peer" before, so they result in the different routes, if the Client c...
After Opened a Case, the problem has been resolve.because the SP drop such bad packets, so you can't caputer them by normal way.The TAC give out some internal commands, make the SP to transfer the BAD Packet to a dedicate port, the the sniffer works....
Yes, you can see here, if your SYSTEM POWER USED is smaller than the SYSTEM POWER TOTAL, you can use only one PS to work well. But remember, 2 PS with different Watts(the Power Capacity) CAN'T be worked together!!!====================================...
