Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There is a wireless community that is setup near a client of mine. They have a signal, but it is very weak. What I want to do is put some piece of hardware in that can sit on top of their trailer and then connect to a hub that we can plug ethernet ca...
I am using a Cisco 350 series access point and I keep having problems with my users picking up other SSID's and attempting to connect to them. I am using 128 bit WEP encryption on my SSID and there is some form of encryption on the rogue SSID's. They...
I have a 350 series wireless bridge and every so often it will just stop working until it is power cycled. Before power cycling it, the LED's will just all be on solid. I did have a power spike a few weeks back that damaged other equipment that was i...
I have a 1720 series router and I suspect that one of the users on my LAN is infected with a virus that is causing the internet access to perform very slowly. All I have setup really is NAT to translate the private addresses to our one public address...
This seems like it would work, but with this product is it necessary to have a workgroup bridge on each end? I do not have any control over the wireless network that I will be connecting to. Also, does this product support one of the more powerful an...
Thank you for the fast response. It turns out that the lightning took out a hub that the Wireless Access Point was plugged into. It not only cause the Wireless Access Point to not function but none of the other access points that I have here function...
