Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Im having issues logging in through the management port on the front of the 2960x. Current config FA0 port config:Building configuration...
Current configuration : 72 bytes
!
interface FastEthernet0
ip address 192.168.200.11 255.255.255.0
en...
Hello,
This is a noob question but i am doubting myself so i wanted to drop a discussion here to get the answer. In our current network, i am building out a management vlan so that SSH traffic and such can be used rather than through the normal dat...
Hello,
Hoping someone can help out with this very odd issue and im sure its something i am overlooking.
We have just changed out our core router from a cisco 2821 to a brand new Meraki MS425 fiber switch that is running all of our layer 3 now. Al...
Hello,
I am hoping that someone can help me. I am pretty good with Cisco but not so great with QOS, let me explain my situation.
Our current location has 2 different l2 switches that are not doing any routing at all. Those are the 2948 and 2960. ...
Hello,I am not new to networking but i just started at a new company that is somewhat in a transition of network topology. Basically the way things work or are currently setup is we have branch locations that route in on a vpn to a switch which route...
Hello Georg, Telnet says "Password required but no password set" i did not set a password on the line con 0 4 because i want to use SSH.Here is the config:Current configuration : 4268 bytes
!
! Last configuration change at 03:53:42 UTC Thu Apr 13 200...
No, i have already created the actual vlan inside of the vlan table. But assigning the IP address to it is the task i am taking on.
So based on what you said i should be good. Just want to be sure is all.. Thanks
I did not have the default gateway set on the switch so unless it was inside a tagged vlan it did not know where to route the data. Pointing my DG to the right place resolved my issue.
