Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If i switch the port channel mode on a blade in catos 6513 does it cause disruption to the entire blade or switch. I am switching from pagp to lacp for a nas
i have 3 switches where the tacacs is not working on them 1 is a 3750, 2 4506.local loging will not work either.the same tacacs configs are on every switch over 100 and only 3 are unable to authenticate.Any ideas would be nice.
I have an ASA and would like to load balance between 2 service providers.I have 1 metro e link and 1 dsl between seperate providers. Is there some way to load balance between the 2 on the ASA.
i have AIR-ANT2506 installed on ap's for outside and it seems as though i am loosing signal strentgh on them when i investigate the ant is filling up with water due to the lip that is on them. is there a model better suited for my needs.
that command is not listed this is the config i have. i am trying to stop people from looping the switch and looping hubs is there a command for this config or features i can enable/disable to prevent this from occuringWS-C6509 Software, Version Nm...
scratch the last comment is there a preferred method to update it via the config listed below.WS-C6509 Software, Version NmpSW: 6.4(9)Copyright (c) 1995-2004 by Cisco SystemsNMP S/W compiled on Mar 10 2004, 17:31:52System Bootstrap Version: 7.1(1)Har...
