My equipment is a cisco 2610 IOS c2600-i-mz.122-10b.I configured the following static route:ip route 172.16.104.0 255.255.254.0 172.16.32.2Ethernet 0/0 address is 172.16.32.1/20I can ping the gateway 172.16.32.2 and the router is applying the static ...

Two cisco 2620XM, 128Mb Ram and 32Mb Flash and IOS c2600-is-mz.122-15.T13.bin, are active on the same Lan, with the hsrp function enable. One it's connected to the primary link and the second one starts isdn calls when the primary link goes down.We c...

I have to configure a couple of cisco 2621xm. One must be connected to a primary link and the second one to 4 isdn lines for backup of the primary one.Ospf will be used as routing protocol and I have to configure hsrp too (and also a backdoor access ...

I installed a NM-1T3/E3 module in one cisco 2621xm and the "sh ver" command seems to show that the router is recognizing it:**************************************************ROM: System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1) R...

May please somebody help me to configure a couple of cisco 2620xm, one provided with a Wic-1t and connected to a node through a leased line, which must be configured for a Gpns service.The second has provided with a 4 Bri module and performs the back...