Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I`ve currently got a link running EIGRP AS 100 across it. I`m wanting to change the interfaces and therefore WAN IP`s of the link. The new link is 2Mbps (MPLS) whereas the old link is 256Kbps (Kilostream). As far as i can see there are two options. F...
Hi,I`ve had a frame-replay config working to a remote satellite location for over two years now, and on Monday it stopped working. This btw coincided with the tech at the location playing around with thier sat modem. Anyway, since then the modem has ...
Can anyone answer me this question?You`ve got two routers (RouterA and RouterB) and are runnign VoIP across the WAN between the two. If i wanted to dial into a modem hanging off of RouterB, then where do i execute the modem passthrough command - i pr...
Hi,I`m about to deploy an ACNS box at the end of a low bandwidth, high latency link (531ms on average). Has anyone had any experience of deploying these in similar situations?Cheers
Okay - sorry about the confusion. Please bear with me.I am trying to do the following.I have a c3662 router and a Cisco Cat switch.I want to run 12 IP phones with PC`s off the back of them. I also have a video conference on a different VLAN at presen...
Thanks.My data Vlan is 1My voice Vlan is 2My video conference Vlan is 3So, my voice ports will look like thisinterface FastEthernet0/X switchport access vlan 1 switchport trunk encapsulation dot1q switchport trunk native vlan 1 switchport trunk allow...
I`ll take the auto-qos out - wasn`t comfortble with it in!That was the plan - the router will connect to the switch (with the first configure on the earlier note) and then that switch is connected to sme non-cisco gear. The Ip phone and PC`s wil han...
