Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried to setup a 802.11a wireless backhaul using several dual radio AP1232AG with IOS 12.3.8JA and LRF feature. The backhaul consists of a root bridge followed by a daisy-chain of two non-root bridges. Usually non-root bridges only associate to roo...
In our network we use a GRE tunnel to connect our WLAN hotspot routers (1760) via the internet to the central service area. In addition to secure the NMS traffic from/to the router we configured an IP Sec tunnel within the GRE tunnel (esp des). To ov...
After a "copy tftp running-config" command an AP1100 was printing an error message and did not apply the commands in the downloaded file into the running config of the AP:228004224752-1_4#copy tftp://172.28.27.248/test/fixedIP-10.0.64.1.cfg.25164 run...
Within Wireless LAN were using ATM as transport network between 2621XM hotspot router and the SSG. In the past we used NM-4E1 on 2621XM. Due to EOS we needed to use AIM-ATM-4E1 now. The configuration of the new ATM interface card is different from NM...
Yes, thanks! The problem was a previous tftp download running at AP startup.The downloaded file contained a command which was waiting for user response and the AP seemed to be still in config mode.After modifying the command the subsequent tftp downl...