Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We ordered two WAE-7341-K9 devices with application acceleration code but received content engine code. Is it possible to just install the oe7341-4.1.7.11 code or do we need to send them back to the vendor and get new devices with the correct ...
Was studying for CCNP exam 642-801 and read this about IPv6;"The IP routing protocols that support IPv6 are RIPng, OSPF, IS-IS, and BGP-4, as of Cisco IOS Software Release 12.2T and later."I know that IPv6 is not widely used yet. What happens to tho...
Hello,I was able to switch code products using the recovery CD-ROM.Some things I learned.It took about an hour then I had to reconfigure them and add them back to CM; so about 90 minutes for each device. While you can back up the config and reinstal...
Thanks for the quick response. I did see some recovery documents but wasn't sure aboutchanging code types. I'll give this a go over the weekend and post back the results.Thanks again,Sean
What code version is running on the working verses non working routers?Vandyke's support forum has some info. Some users report that Putty works fine for them but sCRT stopped after upgrading past IOS 12.2.4.15http://forums.vandyke.com/archive/index....
