Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured this ospf topology like this below with goals is every node can access each other.
PKT file : https://drive.google.com/open?id=1c6g0tgbqI9S2FKl9JREWGPjnKmXWRWmyProblem : From R1_area1 cant connect to local area network(server) and...
In this pkt file I attempt to make
1. IPv6 CONFIG 2. RIPNG 3. EIGRPv6 4. OSPFv3 5. ROUTE REDISTRIBUTION IPv6 6. WAN PPP
I enable ripng NXT-R6 same with NXT-R1, NXT-R2, NXT-R3, NXT-R4, NXT-R5 with this
The running config is in spoiler below
ipv6 rip N...
I have superlab
1. VLAN
2. TRUNK
3. INTERVLAN ROUTING
4. DHCP
5. OSPF
6. FRAME RELAY
7. BGP
8. ETHERCHANNEL
9. ROUTE REDISTRIBUTION
with topology like this belowSuperlab 9Until NXT-Core-Network & NXT-R1 I can ping but after that device I can't ping ...
I create topology like this belowLAB 7to implement the protocols1. VLAN
2. TRUNK
3. INTERVLAN ROUTING
4. DHCP SERVER
5. DHCP RELAY
6. OSPF
7. STP
8. HSRP
9. VTP
10. RIP
11. EIGRP
12. BGP
But for PC & Laptop failed to get DHCP, I Already trace my con...
I didnt get ip address for my Client PC & the error message is "dhcp failed apipa being used" I try to make DHCP server on Router, DHCP Relay on Multilayer Switch & Vlan on Switch.
This is the topologyDHCP, DHCP Relay & InterVlan
https://drive.go...
