Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,
I have install packettracer on Ubuntu 18.04 LTS. It works almost perfectly, I only noticed a small problem.
When I use this command packettracer filename.pka . Packet Tracer stars without loading the file filename.pka. So, I need to...
Hello,
I configured an ether-channel between S1 and S3.
All the switches are in the same vlan, and PVST+ is enabled on all of switches.
Now, I don't understand why does S2 have one link up connected to each switch ? does it not create a loop by this ...
Hello,
In the following topology, I was asked to implement the inter-vlan routing on the layer 3 switch MLS.
The activity progress counter shows 100% but I see a vlan mismatch on both of S1 and MLS. I don't understand the reason.
%CDP-4-NATIVE_VLA...
Hello,I'm a beginner, I'm working on Cisco switch 2960s, and I need some advice about authentication methods to access the LAN (and not the switch).I have a set of vlans that can be divided into two subset according to the authentication methods.In t...
Hello,
I was trying to connect to my switch using RJ45-to-USB adapter, like the one shown in the photo:
I failed to get access, and I got the following messages under Linux's dmesg :
[ 183.932077] usb 1-1.2: new full-speed USB device number 7 using ...
