Thank you for your prompt reply. Unfortunately, this is not a viable solution as it will defeat the whole purpose of access control.
Is there any other solution you can think of that will do the trick?
... View more
We recently implemented port security on almost all of our access catalyst 2960-x switches, but are encountering some issues whereby if USER1 uses his laptop on a configured port-security port, he will be able to access internet (or any network resources) compared to if he uses his laptop on a different non-configured port-security switch whereby he wont be able to access any network resources (even ping fails) unless, port-security is turned off from his original access switch
1. Switches are trunked together
2. Access vlan is 1
Running-Config (Port Security Switch):
SW-01-SEC#sh run int gig1/0/1 Building configuration... Current configuration : 265 bytes ! interface GigabitEthernet1/0/1 switchport mode access switchport voice vlan 100 switchport port-security maximum 2 switchport port-security switchport port-security mac-address sticky mls qos trust cos spanning-tree portfast
Running-Config (Non Port-Security Switch):
interface GigabitEthernet1/0/37 switchport voice vlan 100 mls qos trust cos spanning-tree portfast
Can anyone assist as to why this issue is happening?
... View more