Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi !I've a strange behavior with my ethernet converter DLink DWL-G810 and two AP (1120 and 1121 - 802.11b and 802.11b/g radio).I got lot of "%DOT11-6-ASSOC:" and "%DOT11-6-DISASSOC:" for converter This is my dotradio int configuration:interface Dot1...
Hi !!!I've a bit strange question...How I can add another callmanager to my CM LIST (call manager express 3.1)I need to pass to my phones these info:Callmanager 1: private CME IPCallmanager 2: SRSTCallmanager 3: public CME IPSo, phones outside my LAN...
I try to setup this kind of installation but nothing The non root bridge can't associate to a wireless client or to another AP but only to the root bridge.In Cisco web site I read that this setup seem to be possible.How ???Regards,Salvatore
Uhm...IOS is upgraded to latest version available on cisco site and auth is OPEN (not wep or other crypto key...)I've set countermesure tkip hold-time to 0 and 1 but problem persist...Damn AP Regards,Salvatore
Huhm,I tried some changes on config and now I've no more "Interface reset".Deauth / Auth still the same, but now I'm trying with dot11x parameter...Bye,Salvatore
