1310 Bridge only @ 802.11b

[ansanis]

It's possible to force a 1310 bridge to operate "only" in 802.11b standard, so I can extend cover range on my test site ?

Regards,

Salvatore

[mikespenard]

Limiting the supported data rates should effectively

do this for you. Which is under the device settings

page.

[ansanis]

Uhm, so if I set 11 Mbit/sec like max transfer rate I can raise max power to 50 (or 100 if I need) mW ???

Regards,

Salvatore

[dixho]

You should able to set the power for 802.11b. 802.11b uses CCK; while 802.11g uses OFDM. You should able to set the transmit and receive power for CCK to max; regardless if 802.11g is enable or not.