Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have a ASA 5510, I have configure 2 VPN, router 850-ASA is OK, but I can't establish the other VPN ASA-Astaro, the error is:Jul 09 15:35:57 [IKEv1]: Group = 200.50.2.114, IP = 200.50.2.114, QM FSM error (P2 struct &0x3bcd8c0, mess id 0x4f4f1e...
Hi AllI have a ASA 5510, I have configure 2 VPN, router 850-ASA is OK, but I can't establish the other VPN ASA-Astaro, the error is:Jul 09 15:35:57 [IKEv1]: Group = 200.50.2.114, IP = 200.50.2.114, QM FSM error (P2 struct &0x3bcd8c0, mess id 0x4f4f1e...
Hi AllI have a cisco router 3620 I have configured 20 VPN for my branches offices, the problem is that the load of the CPU arrives at 100%, my conection for this central router is 2 mbps but the traffic average is 600 kbps, my problem not is traffic,...
Hi All, I have a VPN between my NOC and a remote point, I want that the internet access (browse, mail etc) of my user in the remote point use the proxy of my NOC, I need that they use the internet of my NOC.I need to control the access to Internet, a...
Hi AllI need to upgrade the catalyst 4006, where can I found the IOS?, in the cisco site product->Cisco IOS Software I not found IOS for Catalyst 4006.Thanks
Hi,I have problems to enter to console, the console ask for password, and the paasword that I have set no match.finally I have the following message:Starting Off-line DiagnosticsMapping in TempFsBoard type is WS-X4013DiagBootMode value is "post"Loadi...
Hi PaddyI need to know The traffic for each IP, for the IP 200.9.172.2 and IP 200.9.172.3, this IP are global for my two private networks.I have enable SNMP in my router 3550, I work with mrtg, but I only can see the total traffic in my interface, I ...
