Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Application – Cisco Prime Infrastructure 3.4.1 – the appliance is displaying incorrect client information, client counts, client statistics, etc since 22/4/2019.Cisco Prime Infrastructure 3.4.1 Device Pack 7 I have attached an export of the system jo...
On one of our Cisco 9300 switches some of the ports have stopped working. The show as not connected despite the fact they are. On three of these ports TDS is constantly running since yesterday. The devices connected to interfaces Gi1/0/13 and Gi1/0/1...
We have performance issues between storage devices (IBM v9000) that terminate of the below 10GB interfaces. This is part of our DR solution on this system. The slightest delay will place RISK on the business if this is not up to date
TE1/3/2 Redd...
The ASA keeps alerting on our monitoring tool as being 'down'. These outages are lasting a few seconds. In every instance the ASA does not failover to the standby unit. It is the inside interface which is alerting
------------------ show failover -...
One C2960X switch from the switch stack is stuck in a loop
The switches were running c2960x-universalk9-mz.150-2.EX5.bin we was attempting to upgrade to c2960x-universalk9-mz.150-2.EX5.bin.
All other switches upgraded to that version without an issu...
The problem started on the morning of 22/4/2019 – no changes have been made, the department was closed due to Easter Monday and nobody was working that day. No recent changes have been made or scheduled.. Some of the system jobs (Client Statistics, R...
# sh failover interface interface LAN-Failover GigabitEthernet0/3 System IP Address: 10.1.0.1 255.255.255.0 My IP Address : 10.1.0.2 Other IP Address : 10.1.0.1
# sh run failoverfailoverfailover lan unit primaryfailover lan interface LAN-Failover G...
