Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a CISCO1921 with IOS 15.3(3)M5 and its behaviour differs from what I would expect from the config.Overview:10.4.10.0/23 local network for clients (no overload, web access via proxy, see below)10.4.12.0/24 local network for guests10.4.14.0/24 l...
Hello folks,
I have a hard time getting my head around Firepower deployment on ASA5506-X, managed with ASDM. I'm trying to follow the manuals but just don't get it.
Could anybody tell me the configuration needed (CLI) to match traffic that should...
Hello folks,
I just configured SSLVPN on an ASA 9.8 for the first time - it works as expected. However, users connecting to the ASA get a warning from Cisco AnyConnect: "Security Warning: Untrusted Server Certificate!".
This makes sense as I gene...
Hello folks,
I'm not 100% sure if I understand the following output right, so: Will I be able to activate ipservice license on this switch stack? Does having an ipservice license shown in Index 5 mean that it's available for activation?
TLDR:
I...
Hello,
i'm trying to set up CiscoAnywhere with ASA and certificates. When i'm trying to connect, CiscoAnywhere aborts with error "Certificate Validation Failure", but the CLI output with "debug crypto ca 255" enabled seems fine to me.
Do I overse...
Hello guys,
thank you very much for your input! Turned out we already did it like this..
We still see no events in ASDM -> Monitoring -> FirepowerA "tcpdump -i eth0" in expert mode on the Firepower module shows nearly exclusively udp trafficAltho...
Hello Georg,
thank you very much for your feedback. If i get this right, "Active" rather means "available" than "activated". So we're going to purchase ipservice licenses - which brings me to another point of confusion:
If I issue a "show license...
