Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a ASR 920 (ASR-920-12SZ-IM) currently on loan from the Amsterdam Demo Depot and I would need some help in configuring ethernet virtual connections. I have no experience in configuring these services. I have attached a drawing to...
Hello, I have set up a iPSK SSID on a Catalyst 9800-40 controller and this works fine for now.The MAC address of the device gets checked by ISE and if the WPA2-Key is correct then the device will be assigned the correct VLAN. However, with iOS 14 App...
Hello,I am currently implementing Cisco ACI Version 4.2(2e) and have some trouble with IP Multicast originating from via L3-Out.I think it has something to do with the fact that the IP Multicast streams are all within the 232.0.0.0/8 range but in fac...
Hello,we are currently implementing our ACI fabric and have Version 4.1(1i) running.Is there a way to enter MAC addresses into the ACI configuration and preconfigure which EPGs this MAC address will be part of? So as soon as the endpoint is connected...
Hello folks, I recently installed version 6.2 of the Smart Software Manager Satellite. In order to use https for registration without error messages I would like to install a public SSL certificate on the server. Unfortunately I cannot find any infor...
Solved it. I need a bridge domain in order to glue ingress and egress interface together.It says so in the documentation "a service instance must be attached to a bridge domain".
I think I might have found the solution... it probably is a MTU problem after all.
The link between rtr1 and rtr2 still runs on a MTU of 1500 because it was never changed.
So increasing the MTU to 9216 on the 10G link between routers might remedy...
The MTU thing always comes up but I don't think its the problem here. I have attached a simple drawing of the setup. Here are the config bits:
FTD-Config:
!interface Port-channel10.520 vlan 520 nameif inside-po10.520 cts manual propagate sgt preser...
Hello everyone,
sorry for my very late reply but I was sick for a few days and away from the console...
Here is some more information with config snippets and some OSPF output.
Cisco ASA OSPF Config:
router ospf 1 router-id 172.23.249.166 net...
The OSPF adjacencies are up in all three directions.
The routes which originate from the inside router can be seen on both outside routers. Routes originating from outside routers can be seen on the inside router.
This only affects prefixes origi...
