Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I’ve got one of these and I would like to access it via a gui, what’s the simplest way to do, at the moment all I can see is the vlan IP address and all the other ports are unassigned when I do a sh ip int brief. What’s the easiest way to do it? Sti...
So I have been given one of these after a store upgrade that I've been working on, Im quite IT literate and I can console into devices but without guidance this is where my knowledge stops, I want to use this AP for home use, when I plug it in, I get...
I have got a Cisco Air Cap 1602 Wireless AP
I have it connected to a switch, I can see it on my router page but I can't get into the web page to configure it.
I can see it when I console in with Putty , this is where Im stuck, I just want to use ...
Thanks, that's the best vid I've found , thanks, however now when i try i get the error message when trying to read the file.Tar checksum error in fd 0Any ideas?
Thanks, that's the best vid I've found , thanks, however now when i try i get the error message when trying to read the file .Tar checksum error in fd 0 Any ideas? Thanks
Hi, managed to find the file but having loads of issues, the console view keeps jumping with error messages, are you able to helpThe top lines are directory of the flash 2 -rwx 0 Mar 1 1993 00:00:35 +00:00 config.txt3 -rwx 206 Mar 1 1993 00:00:15 +00...
Hi. Yeh after some searching I can see that’s where I now need to be, my problem is getting the image file for autonomous, which I can’t get from anywhere which means I’m now not going to be able to do it unless you know anywhere else I can get it ...
