Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am testing and creating a MOP for upgrading our Supervisor 1 to Supervisor 2E on our production Nexus 7010 chassis using NXOS 6.2(12).Does anybody know what files should I move? I was kind of hoping of using a USB thumb drive to move the files.Any ...
I need to close down SSH access to pass a pre-deployment security scan to our 3845 running c3845-spservicesk9-mz.124-9.T4.bin. I have defined an ACL and applied on the inbound interface;access-list 105 deny tcp any any eq 22access-list 105 deny u...
Hello.I am doing pre-deployment testing for 7.2 on a PIX535. I started pumping engineered ICMP traffic from IXIA at 75MB and 64 frame size just for traffic flow validation (allowed via ACL). For some reason, the CPU spiked to 99%. I was under the imp...
I am running FWSM 2.3(3) and need to upgrade to 3.1(4). Booted maintenance partition to check version 2.1(2) requirement. I found that mp is up to date.After "hw-module module 1 reset", I cannot access the FWSm anymore. 6509-SW-01#sess slot 1 pro 1Th...
"show conn" does show 2 connections and is coming from the IXIA to remote destination. I was thinking that it probably is the limitation of the PIX. I am pumping 148,800 frames per seconds of ICMPs and every one of those frames will go through the PI...
thanks friend.The power is applied to the module as indicated when you do show power.I tried doing "hw-mod module 1 reset mem-test-full" but that did not solve the problem.I think the problem is related to the FWSM failover. On the redundant FWSM, it...
Yes but I want to enable specifically on some ports but not on some. My problem is the port is suppose to go err-disabled once it receives BPDUs on the port. But for some reason the port goes forwarding. even when BPDUs appear on the port. Could be a...
- SP Port speed are the FRTS access rate (AR), right?- The IOS that I have does have FRTS implementation within CBWFQ. Would you have any idea what IOS version is this supported?Thanks.
