Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I believe all you need to do is just make sure the end with the DCE has a clock rate set. This end will provide clocking for the line. You only need the clock source line commands if you have internal CSU's on your routers.I also think your IP i...
Hi,Couple of Thoughts on this:1. The frame carrier's CIR is the guaranteed bandwidth for your connection. You could order a T-1 Port with a 768K CIR. The provider will guarantee you 768K. Anything sent above that would be discard eligible. Obvio...
Hi,You probably need to make sure the static routes you added so you can ping the frame sites are redistributed into the provider's MPLS cloud. Either that or have the provider point to your site for the gateway of last resort. That way all traffic...
Hi Suresh,You don't have any floating static routes to send traffic to the dialers. The backup int command only keeps the dialer in standby mode and EIGRP is denied from being interesting traffic to trigger a call. Try adding a static route for a d...
VKSP,This filter is blocking IP Protocol numbers 11, 53, 55 and 77 as well as PIM for MC. Take a look at the below link. It gives a listing of the protocol numbers and what they are.http://support.microsoft.com/default.aspx?kbid=289892Regards,Danny
