Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using XR 3.6. When I sh ip route from router A to directly connected router, router B,(using loopback address), I will get route metric 65536. Thus makes this link is not prefered (as it has another path to router B).Its connected thru FastEt...
Hi,I have MRTG server that having IPv6 address. My core routers are running dual-stack.My question, how can I monitor router's interfaces that is running dual-stack? I only want to plot for IPv6 MRTG graph.What MIBs that I should have inside my serve...
I have cisco 7606 with module WS-X6724. I have configured mpls mtu 2000 on the router interface configuration (P router). However when we tested from MPLS VPN CE to CE ping test, we cant achive 1500 bytes end-to-end. We transfered the link to use Ge ...
I have setup VPLS in our network. We discovered that MTU pass thru is only 1478 bytes end to end (CE to CE). Unlike MPLS VPN, end to end is 1500 bytes which is normal (CE to CE). Is this normal for VPLS or EToM?As what we experineced before in MPLS V...
Hi,I have deploy this to my network. I have created VPLS and the PW is UP. But i cant ping from end to end (CE to CE). What is the possible problem?--mazlan
Hi Giuseppe, I have resolved the problem.The problem lies with mpls ldp sync which is enabled but not synced so ospf willadvertise max metric.After I removed mpls ldp sycn under router ospf, I now get the real cost and it is using the right path.RA#s...
Hi Giuseppe,The Default Cost of an OSPF Interface Is 100,000,000 Divided by the Interface Bandwidth.You are right that the cost to reach the loopback interface is the cost of the FastEthernet interface plus the cost of the loopback interface, in this...
Hi,If I configure max-metric router-lsa, router A will advertise a maximum metric so that other routers do not prefer the router A as an intermediate hop for other links as well.I tried to make Fe interface which connected directly to router B being ...
