Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all. Hoping you can help me with 2 issues we have after setting up guest wireless using WLC rev 4.2.61.0.1. I set up the guest wlan with pass-through so we can have users accept terms of use. I created a custom page (login.html), created a tar fil...
Hi everyone. I hope somebody can clarify this for me. We are installing LWAPP 1242 APs and we are having problems powering the APs on our 6500 switches. The AP powers up but the radio is disabled. We are using 6348-45V and 6148-45V POE blades. Our ...
Hi all,We are deploying Cisco 1242 wireless in our campus. In a couple of our buildings we have long hallways (>200ft) with glass exterior walls. We are thinking of using Yagi AIR-ANT2410Y-R antennas to cover the long hallways. Questions:1. Is there...
On our 4506 switch I am getting the following errors:Jul 15 09:17:00 CDT: %C4K_EBM-4-HOSTFLAPPING: Host 00:20:E0:CC:56:E9 in vlan 21 is flapping between port Fa2/3 and port Fa2/6Jul 15 09:21:34 CDT: %C4K_EBM-4-HOSTFLAPPING: Host 00:20:E0:CC:56:E9 in ...
We have a Tandberg MXP unit that disconnects intermittenly when connected into a 6148AF blade. When we use a 6348 blade or 3750 switch we do not have issues. We've disabled port security, unicast packet flooding, inline power but it still disconnects...
Thanks Scott. Following your advice, we will be using patch antennas at both ends of the hallway. Did a survey and the patch will work out fine for what we need. Thanks again for the advice.
Unfortunately, we don't see anything on the switch. It just seems to think that a device disconnected. However, our logging is set to defaults so we'll be setting that to show everything.
We are having the same exact problem. We've done what you've tried with no luck also. Strange thing is that in another building we have the same setup but only with a 6148V blade and that Tandberg has no issues. We're using a 6148AF with the one we'r...
