Hello,I have installed NDFC and added 2 SWs (Model: N5K-C5548P), both SWs have only 2 cards ,,, Eth1/x and Eth2/x ,,, but when I added and sync the switches, wrong info were added to NDFC (Eth101/1/x) with Sync Status (NA) as shown in the attached ph...
Hello,Enhanced Classic LAN: For only Nexus 7k and 9k, right?I can see all the below types have the same description, so can anybody give a detailed explanation of each type (when I use each of them?)1- Custom Network2- Classic LAN3- External Connecti...
Hello,I have N5K-C5548P and configured keepalive link between 2 SWs ,, as L3 then I got an issue,, after troubleshooting and search, the solution was either install LAN_BASE_SERVICES_PKG license or L2 Interface mit int vlan ,,, I did the second optio...
Hello Team,
I got a problem after installing CISCO PI [CISCO-Prime-PI-VA-3.3.0.0.342], I installed it on VMware Workstation as a trial version. I can access it normally through CLI, but GUI doesn't work. Noting that I get the below outputs.
CISCO...
Hello,we have the same issue for interface that are not on the SWs (cards are not installed) and I reported the issue but nobody replied till now, hopefully that we get a reply here Regards
thanks so mcuh for your support, actually there are no blocked ports as per the below output ,, I will try to install the license but not sure because this is a lab enviornment.!SW-NDFC-POC-A(config-if)# sh spanning-tree summary totalsSwitch is in ra...
